Welcome to the official website of Wenzhou Weituo precision mould Co., Ltd!
location:HOME > NEWS > Company News
Electrical connection and replacement of the optical controller
The light controller of the wiring type can be directly connected and installed according to the correct connection method in the upper right figure. The locking type controller should be equipped with a receptacle, and the receptacle should be insta
Phone
vitop@vitop-mould.com 0577-62581788
details
  • The light controller of the wiring type can be directly connected and installed according to the correct connection method in the upper right figure.
  • The locking type controller should be equipped with a receptacle, and the receptacle should be installed and connect using the correct connection method shown in the top right image.
  • The electrical connection of the light control unit should be performed with the power supply disconnected.
  • When installing the twist-lock optical controller, Insert the light controller into the socket and rotate it clockwise about 15 degrees to lock it in the socket.
  • Remove, the first counter-clockwise rotation of about 15 degrees to the bit, pull up to remove.
  • The outdoor lighting with a locking type light controller, if not to use the light control mode, you can use twist-locking short-circuit cap instead of light control, then the lamp can be controlled by ordinary switch; 
  • if temporarily don't use lamps, you can use twist lock Open cap instead.
  • outdoor light with a wired optical controller, If light control is not used temporarily, you can use the appropriate way to cover their photographic eyes, this time by the general lighting control switch.


NEXT:2022 Ningbo International Lighting Fair
Service wins reputation, quality wins brand